Furuno UAIS TRANPONDER FA-150 Operator's Manual page 55

2. INLAND AIS
29. Enter the total number of persons (sum of crew, passengers and shipboard
personnel) onboard then press the ENT key.
Note: NO. OF PERSONS is sent in IFM16 messages.
30. Press ► to go to the LENGTH&BEAM sub-menu.
31. Enter the length and beam of your ship, pressing the ENT key after entering
each item. (If LENGTH OF SHIP is more than three meters greater than the
LENGTH OF CONVOY (A+B total for INT ANT POSN or EXT ANT POSN),
the message "DIFFERENT FROM ANT POSN VALUE" appears. The same
message also appears when the value for BEAM OF SHIP is more than
three meters greater than the total for the BEAM OF CONVOY (C+D ANT
POSN.)
32. Press ► to go to the OTHER sub-menu.
33. DYNAMIC INFORMATION RATE is selected; press the ENT key. If the
report rate from a base station is used, this setting is ignored. For that
reason, this setting is not always the same as the actual report rate, which
appears on page 2/2 of the DYNAMIC DATA screens.
34. Select AUTO, 10S, 5S or 2S as appropriate then press the ENT key.
Note 1: This setting is fixed to AUTO in the SOLAS mode.
Note 2: The new rate takes effect in 4-8 minutes. In the meantime the rate
is AUTO, regardless of the indication.
2-6
[LENGTH&BEAM]
LENGTH OF SHIP
0.0
BEAM OF SHIP: 0.0 m
[OTHER]
DYNAMIC INFORMATION
RATE: AUTO
HAZARDOUS CARGO:
UNKNOWN
UN/LOADED: UNKNOWN
m