Maintenance, Troubleshooting; Maintenance - Furuno UAIS TRANPONDER FA-150 Operator's Manual

3.

MAINTENANCE,

TROUBLESHOOTING
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment.
Only qualified personnel
should work inside the
equipment.
3.1 Maintenance
Regular maintenance is necessary to maintain performance. A monthly
maintenance program should be established and should at least include the
items listed in the table below.
Item
Connectors
Cabling
Ground terminal
Ground wire
Monitor unit,
Transponder unit
Do not apply paint, anti-corrosive sealant
or contact spray to coating or plastic
parts of the equipment.
Those items contain organic solvents that
can damage coating and plastic parts,
especially plastic connectors.
Maintenance items
Check that all connectors on the rear panel of the transponder
unit and monitor unit are firmly connected.
Check cabling for damage. Replace if damaged.
Check the ground terminal on the monitor unit and transponder
unit for rust. Clean if necessary.
Check that the ground wire on the monitor unit and
transponder unit is firmly fastened.
Dirt and dust should be removed from units with a soft, dry
cloth. For the LCD, wipe it carefully to prevent scratching,
using tissue paper and an LCD cleaner. To remove dirt or salt
deposits, use an LCD cleaner, wiping slowly with tissue paper
so as to dissolve the dirt or salt. Change paper frequently so
the salt or dirt will not scratch the LCD. Do not use solvents
such as thinner, acetone or benzene for cleaning any unit; they
can remove paint and marks and deform the equipment.
NOTICE
Check point
3-1