Diagnostics - Parking Light Flash Table - Autostart AS-2510 TW Installation Manual

Diagnostics – Parking Light Flash Table
Flashes
Doors locked, Starter Kill armed.
End of Run Time.
button pressed
TRUNK
1
Start signal received by the Remote Car Starter.
Cold Weather Mode cancelled.
Cannot start after maximum number of attempts is reached.
Doors unlocked, Starter Kill disarmed.
Run time cancelled.
2
Exit Remote Valet.
Remote start attempt cancelled by remote.
Entering Cold Weather Mode.
3
Entering Remote Valet.
+12 V where detected on the brake line and cranking was cancelled.
4
Entering Tach-programming Mode
New Transmitter programmed.
5
Tach programmed.
A remote start was attempted while a Tach or a vacuum signal was detected
6
before cranking.
Unit reset: occurs when the Unit is reset to the factory defaults.
8
10 The Hood Switch line went to ground during cranking or Run Time.
There was an attempt to start the vehicle while the Remote Car Starter was
1 – pause – 2
in Valet Mode.
ON solid Cold Weather Mode: the Brake Pedal is being held down.
There was an attempt to start the vehicle while the Remote Car Starter was
2 – pause – 2
in Home Valet Mode.
The Hood is up and the Hood Switch line went to ground. This is step one of
ON 2 sec.
the Programming Centre procedure.
ON 3 sec. First press of the
Locking or unlocking a Door (with Door pulses configured to 4 sec.)
ON 4 sec.
The Hood Pin-switch has been pressed twice: the Unit went into step 1 of the
Programming Centre procedure, and no Transmitter activity was detected for
20 seconds.
ON 25 sec.
Or the Unit went into step 1 of the Transmitter Programming procedure and
no activity was detected for a few seconds. The Unit has exited the
Transmitter Programming procedure.
If the unit gives irregular signals (1 to 10 flashes followed by a pause,
Irregular followed by further flashes), the system is playing back Start Failure Codes.
This occurs when the Hood Pin-switch is pressed three times.
Constant
Panic Mode triggered.
flashes
up to 30 sec.
AS-2510 TW Installation Guide
Description
button under Safe Start.
START
P. 19