Table of Contents
Advertisement
Diagnostics – Parking Light Flash Table
Flashes
• Doors locked, alarm and starter kill armed.
• End of run time.
•
1
• Start signal received by the system.
• Cold weather mode cancelled.
• Cannot start after maximum number of attempts is reached.
• Doors unlocked, alarm and starter kill disarmed.
• Run time cancelled.
2
• Exit remote valet.
• Exit ignition valet
• Remote start attempt cancelled by remote.
• Entering cold weather mode.
3
• Entering remote valet.
• Entering ignition valet
• +12 V where detected on the brake line and cranking was cancelled.
4
• Entering tach-programming mode
• New transmitter programmed.
5
• Tach programmed.
• A remote start was attempted while a tach or a vacuum signal was detected
6
• Unit reset: occurs when the unit is res et to the factory defaults.
8
• The hood switch line went to ground during cranking or run time.
10
• There was an attempt to start the vehicle while the system was in valet
1 – pause – 2
• There was an attempt to start the vehicle while the system was in home valet
2 – pause – 2
• Cold weather mode: the brake pedal is being held down.
ON solid
• The hood is up and the hood switch line went to ground. This is step one of
ON 2 sec.
• First press of the
ON 3 sec.
• Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 4 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the
ON 25 sec.
• Or the Unit went into step 1 of the transmitter programming procedure and
• If the unit gives irregular signals (1 to 10 flashes followed by a pause,
Irregular
Constant
• In horn mode: alarm condition generated by an intrusion, by panic mode or
flashes
up to 30 sec.
Constant
• In siren mode: alarm condition generated by an intrusion, by panic mode or
flashes
up to 60 sec.
Installation Guide
button pressed
TRUNK
before cranking.
mode.
mode.
the programming centre procedure.
START/STOP
programming centre procedure, and no transmitter ac tivity was detected for
20 seconds.
no activity was detected for a few seconds. The unit has exited the
transmitter programming procedure.
followed by further flashes), the system is playing back start failure codes.
This occurs when the hood pin-switch is pressed three times.
when the system is powered up.
when the system is powered up.
Description
button under safe start.
P. 21
Advertisement
Table of Contents
