Table of Contents
Advertisement
Before Programming a Transmitter
The transmitter is not delivered pre-programmed: it must be programmed after the wiring of
the module is completed. The module has the ability to retain up to 4 different transmitter
codes; if a fifth transmitter is programmed, the code of the first transmitter will be erased from
memory.
To program a Transmitter on the second vehicle for Multi-car Operation, you must press the
and
buttons simultaneously (instead of
TRUNK
LOCK
programming procedure:
How to Program the Transmitter.
1.
FLASH the hood pin switch.
Before the 20 seconds have passed, turn the ignition key to the
then to the OFF position.
2.
Press and hold the
stored the transmitter in its memory.
3.
Close the hood, to exit.
How to Enter Programming Options Mode
The system is equipped with two custom programming modes, allowing the installer to
custom-fit the system according to the requirements of each vehicle. When getting into the
programming option mode, the parking lights will flash once, twice depending on the option
you have entered. The unit will stay in programming mode until the hood pin switch or the
brake pedal is pressed again; therefore take your time to make the proper selection. To
return to the programming centre (main menu), press on the brake pedal.
1.
FLASH the hood pin switch.
Before the 20 seconds have passed,
Press and hold the brake pedal, then press one of the following buttons on the
2.
transmitter:
The parking lights will flash once or twice to confirm entry into a mode.
Release the brake pedal.
3.
AS-1414/ AS-1424
Installation Guide
button until the vehicle gives 5 flashes. The module has
LOCK
to enter mode 1;
LOCK
to enter mode 2.
UNLOCK
The Programming
Assistance Button
(A.k.a. PAB.)
The PAB is located on the
side of the module. This
push button mimics the
hood pin switch in order to
avoid having to get out of
the vehicle and pressing the
hood pin switch. The PAB
will work only when the
hood is up.
or
LOCK
UNLOCK
IGNITION ON (RUN)
Table 1
Table 2
) in step 2 of the Transmitter
position and
P. 9
Hide quick links:
Advertisement
Table of Contents
