Table of Contents
Advertisement
The Programming Assistance Button
Caution
The Hood Pin switch must be installed and connec-
ted in order for the Programming Assistance Button
to function. The button will work only when the
Hood is up.
Programming a Transmitter
Before you Proceed
The Transmitter of the Remote Car Starter is not delivered pre-programmed: it must be
programmed after the wiring of the Remote Car Starter is completed. The Remote Car
Starter has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
code-learnt, the code of the first Transmitter will be lost from memory. To erase all
Transmitter codes from memory, you must perform a reset of the Remote Car Starter
(see Resetting the Remote Car Starter, later in this Guide, for more details).
The Transmitter Programming Procedure
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
– Before the lights go out, turn the Ignition Key to the
– Immediately turn the Ignition Key back to the
Press and hold the
5 times quickly.
– The Remote Car Starter has stored the code of the Transmitter into memory.
2. To exit: close the Hood.
Entering Programming Options Mode
The Remote Car Starter is equipped with three custom programming Modes that allow the
installer to custom-fit the system outputs according to installation requirements. The
Programming Options are designed to facilitate interfacing with all vehicle types. (See
section Table of Programming Options later in this Guide.)
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
– Before the lights go out:
P. 10
(A.k.a. the PAB.) Mounted on the
Remote Car Starter, this button can be
used from within the vehicle instead of
the Hood Pin switch in the Engine
compartment. This will spare the installer
the trouble of accessing the Hood Pin
switch in the Engine compartment.
for up to 20 seconds.
ON
OFF
button and keep it down until the Parking Lights flash
LOCK
Table 2: Programming a Transmitter
for up to 20 seconds.
ON
Installation Guide AS-1820 FM
position.
IGNITION ON (RUN)
position.
Advertisement
Table of Contents
