Removing The Rear Adapter Retention Bracket - Lenovo ThinkServer TD200x Installation And User Manual

Removing the rear adapter retention bracket

To remove the rear adapter-retention bracket, do the following:
1. Read the safety information that begins on page vii and "Handling
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the left-side cover" on page
4. Remove all adapters and place the adapters on a static-protective surface (see
5. Open the rear adapter retention bracket.
6. Press the rear adapter retention bracket and release the top hinge point; then,
7. If you are instructed to return the rear adapter-retention bracket, follow all
70
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Installation and User Guide
1
Rear adapter retention bracket
2
Hinge pin
static-sensitive devices" on page 39.
and external cables.
42).
"Removing an adapter" on page 72).
Note: You might find it helpful to note where each adapter is installed before
removing the adapters.
release the other hinge point and remove the bracket from the chassis.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.