Other Messages; Multi-Sensor Error; Garo Wxxxx (X Represents A Number); Error Exxx-Xxxx (X Represents A Letter Or Number) - Canon imagePROGRAF iPF9400S Basic Manual

iPF9400S

Other Messages

Other Messages

GARO Wxxxx (x represents a number) ...................................................................................................... 149

ERROR Exxx-xxxx (x represents a letter or number) .................................................................................. 149

Hardware error. xxxxxxxx-xxxx (x represents a letter or number) .............................................................. 149

Top cover is open. ...................................................................................................................................... 149
Prepare for parts replacement. ................................................................................................................... 150
Parts replacement time has passed. .......................................................................................................... 150
Unknown file. .............................................................................................................................................. 150
Calibration There is a problem with the multi-sensor. ................................................................................ 150

Multi-sensor error ........................................................................................................................................ 150

GARO Wxxxx (x represents a number)
GARO Wxxxx (x represents a number)
Cause
There is a problem with the print job.
ERROR Exxx-xxxx (x represents a letter or number)
ERROR Exxx-xxxx (x represents a letter or number)
Cause
An error requiring service may have occurred.
Hardware error. xxxxxxxx-xxxx (x represents a letter or number)
Hardware error. xxxxxxxx-xxxx (x represents a letter or number)
The last portion of roll paper was used during a print job. The paper was
not advanced because the trailing edge is taped to the roll.
Fastening tape or the Belt Stopper has not been removed inside the Top
Cover.
An error requiring service may have occurred.
Top cover is open. Top cover is open.
Cause
The printer has detected that the Top Cover is open.
Basic Guide
Try printing again, using the correct printer driver.
It is also possible to continue printing in this state.
However, you may not be able to obtain the desired printing results.
Write down the error code and message, turn off the printer, and contact your Canon
dealer for assistance.
Cause
Open the Top Cover fully, remove any foreign objects, and close the Top Cover
again.
If the error occurs again, turn off the printer and wait a while before restoring power.
Corrective Action
Corrective Action
Turn off the printer and remove the roll from the printer before
restoring power.
Turn off the printer, open the Top Cover and remove the tape
or the Belt Stopper before restoring power.
Turn off the printer and wait at least three seconds before re-
storing the power.
If the message is displayed again, write down the error code
and message, turn off the printer, and contact your Canon
dealer for assistance.
Corrective Action
GARO Wxxxx (x represents a number)
Corrective Action
149