The Printer Stops During A Print Job - Canon imagePROGRAF iPF9400S Basic Manual

iPF9400S

The printer stops during a print job

The printer stops during a print job
An error message is shown on the Display Screen .................................................................................... 109
The printer ejects blank, unprinted paper .................................................................................................. 109
An error message is shown on the Display Screen
An error message is shown on the Display Screen
An error message is displayed during printing.
The last portion of roll paper was used during a print job, and paper
could not be advanced because the trailing edge is taped to the roll.
The printer ejects blank, unprinted paper
The printer ejects blank, unprinted paper
Cause
The leading edge of the roll paper was
cut to straighten it.
The Printhead nozzles are clogged.
A print job was received from an in-
compatible printer driver.
The printer is damaged.
Basic Guide
Cause
The leading edge of rolls may be cut to straighten it if Trim Edge First is set to a value other
than Off in the Control Panel menu.
(See "Cutting the Leading Edge of Roll Paper Automatically.")
Print a test pattern to check the nozzles and make sure the Printhead is in good condition for
printing.
(See "Checking for Nozzle Clogging.")
Use the correct imagePROGRAF printer driver for the printer and try printing again.
Contact your Canon dealer for assistance.
An error message is shown on the Display Screen
Corrective Action
Check the error message and take action as necessary.
(See "Error Messages.") →P.151
Remove the used roll and insert a new roll.
(See "Removing the Roll from the Printer.")
(See "Removing Rolls From the Roll Holder.")
(See "Loading and Printing on Rolls.")
Corrective Action
→User's Guide
→User's Guide
→P.15
→User's Guide
→User's Guide
109