Table of Contents
Advertisement
Copier
General operation
Open the copy tray under the following conditions:
When you make 20 or more 8
When you make 10 or more 8
When you use curled paper.
When using OHP sheets, set one sheet at a time into the bypass feed en-
trance and open the copy tray. Remove copies delivered to the copy tray
one by one.
When you use translucent paper under low temperature and low humidity
conditions, it may be misfed. In this case, leave the paper for a while to
make the paper curl face down. Then, deliver the paper to the copy tray.
If there is a large solid image on the original, the Add Toner
may be lit after copying although toner remains in the toner bottle. In this
case, turn the main switch off and then back on again.
Under the following conditions, you might get light copies.
When you make 150 or more copies continuously.
When you make one solid full image copy.
When you make copies when the Add Toner
Copies may be curled after coming
out of the copier. If necessary, un-
curl the paper within 5 mm, 0.2" as
shown before inserting it in the by-
pass feed entrance to make a two-
sided copy.
Keep the used imaging unit horizontal. If you tilt the imaging unit, toner may
be spilled out.
If you move the imaging unit without the toner bottle being set properly,
toner may be spilled out.
Do not expose the imaging unit (especially blue material) to the light.
Do not store the imaging unit under high temperature and high humidity.
When you replace the imaging unit, also change the ozone filter.
DO'S AND DON'TS
" x 11", A4 copies
1/2
" x 14" copies.
1/2
f
DO'S AND DON'TS
f
indicator
indicator blinks.
5 mm,
0.2"
65
Advertisement
Table of Contents
