Table of Contents
Advertisement
4
Take out the new imaging unit
from the black bag horizontally.
5
Put the used imaging unit into
the black bag horizontally not to
spill the toner.
Do not shake the imaging unit to
the right or left.
6
Insert the trailing part of the im-
aging unit onto both hinges.
Then, put the other part of the
unit on the guide plate.
Do not push the imaging unit. This
unit is set only to put it on the
guide plate.
The imaging unit is shaky if you
push it — there is no problem.
7
Completely remove the tape
from inside the imaging unit by
pulling it out as shown.
Hold down the unit with one hand
to avoid turning it over.
Pull out the tape in the direction of
the arrow on the tape. After remov-
ing it, you will find the end mark at
the end of the tape.
CHANGING THE IMAGING UNIT
35
Advertisement
Table of Contents
