Toshiba e-STUDIO453 Service Manual page 60

(3) Disconnect 3 connectors while the switching
power supply is pulled out to the front and
take off the switching power supply.
2 2
[F] Power supply cooling fan
(1) Take off the left cover (
(2) Remove 2 screws and take off the power
supply cooling fan on the switching power
supply.
Note:
When installing, pay attention to the direction
of the wind from the fan.
[G] High-voltage transformer
(1) Take off the rear cover (
(2) Disconnect 7 connectors.
(3) Remove 2 screws and release 2 locking
supports. Then take off the high-voltage
transformer.
Note:
When installing, make sure to match the
colors of connectors and harnesses accord-
ing to the color instruction on the board.
[H] Noise filter
(1) Take off the rear cover and right lower cover
( Chapter 2.5.1 [C] [O]).
(2) Disconnect 4 connectors. Remove 1 screw
and 1 washer. Then take off the noise filter.
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
Chapter 2.5.1 [J]).
Chapter 2.5.1 [C]).
2 - 40 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 2-552
Fig. 2-553
Fig. 2-554
White Black
Fig. 2-555