Toshiba e-STUDIO453 Service Manual page 59

(D-2) e-STUDIO352/353/452/453
(1) Take off the hard disk with the whole brack-
ets. ( chapter 2.5.1 [B])
(2) Disconnect 4 connectors.
Note:
Alternatively, you can take off the SYS board
without removing the hard disk by removing
2 upper and 1 lower fixing screws for the
hard disk bracket and 1 fixing screw for the
ground wire to tilt down the hard disk toward
you.
(3) Remove 8 screws and take off the SYS
board.
[E] Switching power supply
(1) Take off the left cover (
(2) Remove 2 screws. Disconnect 2 connectors
with lock on the front side and 1 connector
while releasing the harness from the holder
on the right side of the bracket.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SYS board
Chapter 2.5.1 [J]).
2 - 39
07/11
Fig. 2-548
Fig. 2-549
Fig. 2-550
Fig. 2-551
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
2