Toshiba e-STUDIO453 Service Manual page 219
Hide thumbs
Also See for e-STUDIO453:
- Service handbook (764 pages) ,
- Operator's manual (362 pages) ,
- Printing manual (356 pages)
Table of Contents
Advertisement
(I-2) Developer unit cooling fan-1
(1) Take off the rear cover (
[C]).
(2) Take off the duct of developer unit cooling
fan-2 (
Chapter 11.6 (I-1)).
(3) Release 2 latches and take off the duct
cover.
(4) Disconnect 1 connector and take off the
developer unit cooling fan-1.
Note:
When installing, pay attention to the direction of
the wind from the fan.
(I-3) Developer unit cooling fan unit-1
(1) Take off the rear cover (
[C]).
(2) Take off the SYS board with the whole case
(
Chapter 2.5.2 [C]).
(3) Remove 1 screw and disconnect 1 connec-
tor and take off the developer unit cooling
fan unit-1.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Chapter 2.5.1
Chapter 2.5.1
- 7
Fig. 11-631
Fig. 11-632
Fig. 11-633
e-STUDIO350/352/353/450/452/453
DRUM RELATED SECTION
11
Advertisement
Table of Contents
