Toshiba e-STUDIO453 Service Manual page 215

(D-2) Recovery blade
(1) Remove the cleaning blade (
11.6 (D-1)).
(2) Remove the recovery blade.
Notes:
1. When attaching the recovery blade, clean the
surface of the frame first. Be careful not to
deform the blade.
2. Attach the recovery blade while pushing it to
the step on the surface of the frame.
3. Press the stuck part with your finger to attach
the blade securely.
(D-3) Separation finger
(1) Remove the drum (
(2) Release the 3 separation fingers.
Notes:
1. When replacing the separation fingers,
make sure that the drum has been taken off
first since the fingers may scratch the drum
surface.
2. When the separation fingers have been re-
placed, check if their pressure movement is
normal by moving them with your fingers.
[E] Transfer / Separation charger
(E-1) Transfer / Separation charger
(1) Open the bypass tray, ADU and jam access
cover.
(2) Release the latches and take off the transfer
and separation chargers.
Note:
When installing the transfer and separation char-
gers, make sure not to deform the springs.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Chapter
Chapter 11.6 [C]).
 - 3
Fig. 11-616
Fig. 11-617
Fig. 11-618
e-STUDIO350/352/353/450/452/453
DRUM RELATED SECTION
11