Toshiba e-STUDIO453 Service Manual page 195

(H-6) Feed roller
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Take off the separation roller
( Chapter 10.4 (H-5)).
(3) Remove the clip and take off the feed roller.
(H-7) Pickup roller
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Remove the pickup roller assembly from the
pickup arms and take off the belt.
(3) Remove 3 E-rings, pulley, one-way clutch
and take off the pickup roller.
(H-8) Drawer feed clutch
(1) Take off the drawer feeding unit (
ter 10.4 (H-1)).
(2) Disconnect the connector and release the
harness from harness clamp.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Feed roller
Clip
Belt
Pickup roller
Chap-
9 - 29
Fig. 9-472
Pickup roller As-
sembly
Fig. 9-473
E-ring
One-way clutch
Pulley
E-ring
Fig. 9-474
Connector
Fig. 9-475
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
9