Toshiba e-STUDIO453 Service Manual page 189

(13) Disconnect 3 connectors of the drive gear
unit.
(14) Disconnect 2 connectors wired from the
drive gear unit.
(15) Remove 5 screws and take off the drive
gear unit.
(16) Remove the E-ring and the bushing of the
registration roller (1 pc. each).
(17) Remove the E-ring and the bushing on the
front side and slide the registration roller
(rubber) to the rear side to take it off.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Connector
Fig. 9-450
Fig. 9-451
Drive gear unit
Fig. 9-452
Bushing
E-ring
Fig. 9-453
9 - 23 e-STUDIO350/352/353/450/452/453
Connector
Connector
Screw
Screw
E-ring
Bushing
Registration
roller (rubber)
PAPER FEEDING SYSTEM
9