Toshiba e-STUDIO453 Service Manual page 183

(3) Take off the bypass separation roller assem-
bly.
(4) Detach the cover, the arbor, and the clutch
spring from the shaft, and then take off the
bypass separation roller.
(A-11) Bypass feed sensor
(1) Take off the bypass unit (
(2) Take off the lower plate (
(A-10)).
(3) Remove 1 screw and take off the sensor
plate.
(4) Disconnect 1 connector, release the latch to
take off the bypass feed sensor.
Note:
Be careful not to come off the sensor arm
and the sensor spring after taking off the
sensor.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Chapter 9.4 (A-1)).
Sensor plate
Chapter 9.4
Sensor Spring
9 - 17
Bypass separation
roller assembly
Fig. 9-428
Shaft
Cover
Bypass separation roller
Fig. 9-429
Screw
Fig. 9-430
Bypass feed sensor
Sensor arm
Fig. 9-431
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
9
Arbor
Clutch
spring