Disassembly And Replacement - Toshiba e-STUDIO453 Service Manual

10.4 Disassembly and Replacement

[A] Main motor
(1) Take off the rear cover (
[H]).
(2) Take off the SYS board case (
[D]).
(3) Take off the developer unit cooling fans-1 &
-2 ( Chapter 11.6 [I]).
(4) Disconnect 1 connector.
(5) Remove 2 screws.
(6) Release 1 locking support and take off the
main motor with the board.
10
[B] Registration clutch
(1) Take off the rear cover (
(2) Take off the SYS board case (
[D]).
(3) Take off the developer cooling fan-2
( Chapter 11.6 [I]).
(4) Disconnect 1 connector, loosen 1 setscrew
and take off the registration clutch.
[C] Gear unit
(1) Take off the rear cover (
(2) Take off the SYS board case (
[D]).
(3) Take off the developer unit cooling fans-1 &
-2 ( Chapter 11.6 [I]).
(4) Take of the registration clutch (
10.4 [B]).
(5) Disconnect 3 connectors.
e-STUDIO350/352/353/450/452/453
DRIVE SYSTEM
Chapter 2.5.1
Chapter 9.4
Screw
Chapter 2.5.1 [H]).
Chapter 9.4
Chapter 2.5.1 [H]).
Chapter 9.4
Chapter
10 - 4 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Connector
Fig. 10-401
Locking support
Main motor
Screw
Fig. 10-402
Setscrew
Registration clutch
Fig. 10-403
Connector
Connector
Fig. 10-404
Connector
Connector