Toshiba e-STUDIO453 Service Manual page 113

No. Message
40 Place the blank
sheets in bypass tray
and select the paper
size
41 Place the blank
sheets in the same
direction as the
originals
42 Place the same size
blank sheets as the
originals
43 Place insertion
sheets in the bypass
tray and select the
paper size
44 Select the same size
insert1 sheets as the
originals
45 Select the same size
insert2 sheets as the
originals
46 Set insert1 sheets in
the same direction
as the originals
47 Set insert2 sheets in
the same direction
as the originals
48 Set transparency film
in A4/LT direction
49 CHECK PAPER IN
LARGE CAPACITY
FEEDER
50 CANNOT PUNCH
THIS SIZE PAPER
51 Remove paper from
the finisher
52 Cannot staple this
size
53 Remove paper from
the saddle stitch unit
54 Examine stapler
55 Check staple
cartridge
56 Check staple cartridge
in the saddle stitch unit
57 Job interrupted job 1
saved
58 Ready to resume job
1
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
State of equipment
Displayed when no paper is in the selected
feeder at Cover Copying Mode
Displayed when the direction of cover page
is different from that of other pages at Cover
Copying Mode
Displayed when the paper size of cover
page is different from that of other pages at
Cover Copying Mode
Displayed when no insertion sheet is in the
selected drawer at Sheet Insertion Mode
Displayed when the size of insertion sheet
(sheet 1) is different from that of other
pages at Sheet Insertion Mode
Displayed when the size of insertion sheet
(sheet 2) is different from that of other
pages at Sheet Insertion Mode
Displayed when the direction of insertion
sheet (sheet 1) is different from that of other
pages at Sheet Insertion Mode
Displayed when the direction of insertion
sheet (sheet 2) is different from that of other
pages at Sheet Insertion Mode
Displayed when the selected paper size is
other than A4/LT at OHP mode
Papers in LCF are set incorrectly
Displayed when the selected paper size is
not specified for hole punching
Displayed when the paper sizes are mixed
at Staple Sorting Mode
Displayed when the paper size is not
specified for stapling at Staple Sorting Mode
Finisher is full of papers
Trouble in the stapler unit in finisher
No stapler in finisher section
No stapler in saddle stitch unit
Interrupt copying is accepted
Interrupt copying is cancelled (finished)
5 - 5
Note
e-STUDIO350/352/353/450/452/453
CONTROL PANEL
5