Toshiba e-STUDIO453 Service Manual page 182
Hide thumbs
Also See for e-STUDIO453:
- Service handbook (764 pages) ,
- Operator's manual (362 pages) ,
- Printing manual (356 pages)
Table of Contents
Advertisement
(A-9) Bypass feed clutch
(1) Take off the bypass unit (
Chapter 9.4 (A-1)).
(2) Take off the bypass tray and hinge assembly
(
Chapter 9.4 (A-2)).
(3) Disconnect 1 connector and release the har-
ness from harness clamp.
(4) Remove the harness clamp.
(5) Remove 3 screws and take off the drive unit.
9
(6) Remove the E-ring and the bush, and then
pull out the shaft.
(7) Remove 3 screws and take off the bracket.
(8) Remove the gear and the bypass feed
clutch.
Note:
Match the protruding portion of the clutch with
the position shown in the drawing for assem-
bling.
(A-10) Bypass separation roller
(1) Take off the bypass unit
(
Chapter 9.4 (A-1)).
(2) Remove 3 screws and take off the lower
plate.
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
Fig. 9-424
Drive unit
Screw
Fig. 9-425
Shaft
Bypass feed
clutch
Bush
E-ring
Fig. 9-426
Screw
Lower plate
Fig. 9-427
9 - 16
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Advertisement
Table of Contents
