Toshiba e-STUDIO453 Service Manual page 56

(5) Remove 4 screws and take off the hard disk
with the whole brackets.
2 2
(6) Remove 4 screws, disconnect 2 connectors
and take off the hard disk. Remove 1 screw
and take off the ground wire.
(7) Remove 2 screws and take off the HDD
cooling fan from the SYS board cover.
[C] System control PC board case
(SYS board case)
(C-1) e-STUDIO350/450
(1) Take off the rear cover (
[C]).
(2) Take off the hard disk with the whole SYS
board lower cover (
(3) Disconnect 4 connectors.
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
Chapter 2.5.1
Chapter 2.5.2 [B]).
2 - 36
05/11
Hard disk
Fig. 2-536
Ground wire
Fig. 2-537
Fig. 2-538
Fig. 2-539
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Hard disk
HDD cooling fan