Toshiba e-STUDIO453 Service Manual page 258

(9) Remove 1 C-ring and take off the cleaning
roller with the whole bushings on both sides.
(10) Take off the bushings from the cleaning
roller.
[H] Pressure roller
(1) Take off the cleaning unit (
[G]).
(2) Remove the pressure springs on both front
and rear sides.
(3) Pull out the pressure lever units on both left
and right sides.
(4) Take out the pressure roller.
13
[I] IH coil
(1) Take off the fuser unit (
(2) Take off the fuser unit cover
( Chapter 13.7 [B]).
(3) Release the harness from the harness guide
of the cover on the rear side.
(4) Remove 1 screw and take off the cover on
the rear side.
e-STUDIO350/352/353/450/452/453
FUSER UNIT / PAPER EXIT SECTION
Chapter 13.7
Chapter 13.7 [A]).
13 - 20 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 13-717
Fig. 13-718
Fig. 13-719
Fig. 13-720