Toshiba e-STUDIO453 Service Manual page 178

(4) Pull out the hinge assembly from the bypass
tray.
(A-3) SFB board
(1) Take off the bypass unit (
(2) Take off the hinge assembly (
(A-2)).
9
(3) Remove 3 screws, 4 latches and 3 hooks,
and take off bypass tray upper cover.
(4) Remove 1 screw and take off the plate
spring.
(5) Remove 1 screw on the tray side and take
off the bracket.
Note:
Install the bracket so that its pointer is
placed at the same position as before.
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
Chapter 9.4 (A-1)).
Chapter 9.4
Bypass tray
upper cover
9 - 12 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Hinge assembly
Fig. 9-409
Screw
Fig. 9-410
Plate
Bracket
spring
Screw
Fig. 9-411
Pointer
Fig. 9-412