Installing The Media Onto The Supply Holder Unit - Toshiba B-852 Series Supply Loading Instructions

Hide thumbs Also See for B-852 Series:

2. Attach the assembled Supply Holder Frame to the rear of the B-852 printer by inserting the hooks of the

Frame into the two slots in the rear of the printer as shown in the figure below.

NOTE:

After attaching the supply holder frame to the printer, make sure that it is assembled firmly

1.2 Installing the Media onto the Supply Holder Unit

1. Disassemble the Supply Holder Unit.

1) Position the Supply Holder Unit as shown in the above diagram so that the Non-removable Supply Holder

is at the right.

2) Rotate the Green Supply Holder Locking Knob in the direction of arrow

the Removable Supply Holder.

3) Slide the Removable Supply Holder in the direction of arrow

4) Rotate the green Supply Holder Locking Knob in the direction of arrow

the Non-removable Supply Holder.

5) Slide the Non-removable Supply Holder all the way to the end of the Supply Shaft until it stops.

NOTES:

1. The Non-removable Supply Holder is the one that slides in the wide slot while the Removable Supply Holder is the

one that slides in the narrow slot.

2. Do not turn the Supply Holder Locking Knob anti-clockwise too far, or it may come off the Supply Holder.

Hook

(counterclockwise) to loosen

to remove it from the Supply Shaft.

(counterclockwise) to loosen

Hook

Table of Contents