(3)
Close the ADF and check if the positioning
pins fit the holes on the ADF.
[B] Adjustment
If the pins cannot be fitted into the holes, perform the adjustment according to the following procedure.
(1)
Remove the right-hand hinge screw at the
rear side.
(2)
Remove the bracket on the left-hand hinge.
(MR-2020 only)
MR-2017/2020
ADJUSTMENT
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
5 - 2
09/12
Fig. 5-3
Fig. 5-4
Fig. 5-5