Toshiba MR-2017 Service Manual page 38

[H] Pre-reading guide
(1) Take off the front cover.
( P. 4-1 "[A] Front cover")
(2) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(3) Take off the jam access cover.
( P. 4-2 "[C] Jam access cover")
(4) Take off the left cover.
( P. 4-3 "[D] Left cover")
(5) Remove 1 screw and take off the hinge pin.
(6) Disconnect 1 connector. Remove 2 screws
and take off the pre-reading guide.
[I] Intermediate transport roller
(1) Take off the pre-reading guide.
( P. 4-12 "[H] Pre-reading guide")
(2) Take off the read motor drive section.
( P. 4-18 "[C] Read motor (M2)")
(3) Remove 1 bushing, 1 screw, 1 pulley and 1
bushing from the rear side of the intermedi-
ate transport roller shaft.
(4) Remove 1 bushing from the front side of the
intermediate transport roller shaft.
(5) Take off the intermediate transport roller.
MR-2017/2020
DISASSEMBLY AND ASSEMBLY
Hinge pin
Pre-reading guide
Screw
Bushing
Bushing
Pulley
Intermediate transport roller
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 12
07/06
Fig. 4-34
Fig. 4-35
Bushing
Fig. 4-36