Motor / Motor Drive Section - Toshiba MR-2017 Service Manual

4.3

Motor / Motor drive section

[A] Original feed motor (M1)
(1) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(2) Disconnect 1 connector, and then remove 1
spring. (Spring: Outside diameter of coil –
ø9.6 mm, acceptable turns of coil – 12 turns)
(3) Remove 3 screws, and then take off the orig-
inal feed motor with its bracket.
Note: Note:
When the unit is being assembled, tempo-
rarily tighten the screws removed at step (3)
and then attach the spring removed at step
(2). Then fully tighten these screws.
(4) Remove 2 screws and take off the original
feed motor.
MR-2017/2020
DISASSEMBLY AND ASSEMBLY
Connector
Spring
Original feed motor
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 16
Fig. 4-45
Fig. 4-46
Original feed motor
Fig. 4-47