Toshiba MR-2017 Service Manual page 44

[C] Read motor (M2)
(1) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(2) Disconnect 1 connector, and then remove 1
spring. (Spring: Outside diameter of coil –
ø10.2 mm, active coils – 12.5)
(3) Remove 3 screws, and then take off the read
motor with its bracket.
Note: Note:
When the unit is being assembled, tempo-
rarily tighten the screws removed at step (3),
and then attach the spring removed at step
(2). Then fully tighten these screws.
(4) Remove 2 screws and take off the read
motor.
MR-2017/2020
DISASSEMBLY AND ASSEMBLY
Spring
Read motor
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 18
Connector
Fig. 4-51
Fig. 4-52
Read motor
Fig. 4-53