Toshiba MR-2017 Service Manual page 40

(3) Take off the read motor drive section.
( P. 4-19 "[D] Read motor drive section")
(4) Remove 1 bushing, 1 E-ring and 1 pulley
from the rear side of the post-reading roller
shaft. Loosen 2 setscrews and take off 1
flange. Take off 1 bearing.
(5) Remove 1 clip, timing belt, 1 pulley, 1pin, 1
E-ring and 1 bushing from the front side of
the post-reading roller shaft.
(6) Open the RADF. Remove 4 screws, take off
2 holders and platen guide.
MR-2017/2020
DISASSEMBLY AND ASSEMBLY
Flange
Bushing
E-ring
E-ring
Bushing
Pulley
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 14
Bearing
Pulley
Fig. 4-40
Pin
Timing belt
Clip
Fig. 4-41
Holder
Platen guide
Holder
Fig. 4-42