[E] Original tray
(1)
Take off the front cover.
(
P. 4-1 "[A] Front cover")
(2)
Take off the rear cover.
(
P. 4-2 "[B] Rear cover")
(3)
Take off the paper feeder unit.
(
P. 4-5 "[A] Paper feeder unit")
(4)
Remove 2 screws. Lift up the feeder upper
guide by sliding it to the right.
Note:
Note:
Do not pull the harness too strong.
(5)
Disconnect 1 connector from the ADF control
PC board.
(6)
Remove 1 screw and take off the bushing.
(7)
Take off the original tray.
MR-2017/2020
DISASSEMBLY AND ASSEMBLY
Bushing
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 4
06/09
Feeder upper guide
Fig. 4-10
Fig. 4-11
Original tray
Screw
Fig. 4-12