Toshiba MR-2017 Service Manual page 39

[J] Pre-reading roller
(1) Take off the pre-reading guide.
( P. 4-12 "[H] Pre-reading guide")
(2) Take off the read motor drive section.
( P. 4-18 "[C] Read motor (M2)")
(3) Remove 1 bushing, 1 screw, 1 pulley and 1
bearing from the rear side of the pre-reading
roller shaft.
(4) Remove 1 clip and 1 bushing from the front
side of the pre-reading roller shaft.
(5) Take off the pre-reading roller.
[K] Post-reading roller
(1) Take off the pre-reading guide.
( P. 4-12 "[H] Pre-reading guide")
(2) Disconnect 1 connector.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Screw
Bushing
Fig. 4-37
Pre-reading roller
Fig. 4-38
Connector
Fig. 4-39
4 - 13
07/06
Bearing
Pulley
Clip
Bushing
MR-2017/2020
DISASSEMBLY AND ASSEMBLY
4