Toshiba MR-2017 Service Manual page 43

[B] Original feed motor drive section
(1) Take off the the original feed motor.
( P. 4-16 "[A] Original feed motor (M1)")
(2) Release the harness from 3 harness clamps.
(3) Remove 1 E-ring and take off the bushing.
(4) Disconnect 3 terminals of the switch.
(5) Remove 4 screws, and then take off the
bracket.
Note: Note:
When connecting the terminal, make sure
that the color of the harness is correct.
(6) Take off the timing belt, bushings and 2 pul-
leys.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Harness clamp
E-ring
Fig. 4-48
Bracket
Fig. 4-49
Bushing
Fig. 4-50
4 - 17
09/01
Harness clamp
Bushing
White
Black
Red
Pulley
Timing belt
MR-2017/2020
DISASSEMBLY AND ASSEMBLY
4