Adjusting The Unit Holder's Position; Attaching The Navigation Device; Removing The Navigation Device; Devices With Magnetic Holders - Becker Active.5s EU Operating Manual

>>> GENERAL OPERATION

Adjusting the unit holder's position

> Loosen the fastening screws
until the carrier plate
5
moved without using excessive force.
> Move the carrier plate
required position and hold it in this
position.
> Tighten the fastening screws
sufficiently so that the Navigation
5
device is held securely in place when
the vehicle is in motion.

Attaching the Navigation device

> Position the Navigation device with the
attachment point on the bottom of the
housing, onto the carrier plate
> Without using excessive force, press
the Navigation device onto the carrier
plate . The Navigation device locks
6
into place.

Removing the Navigation device

Press the button
carrier plate
Navigation device which can be removed
from the carrier plate.
26

Devices with magnetic holders

and The unlocking button
4
can be First place the navigation device with the
6
upper mounting point onto the carrier
to the plate
6
device. The magnet holds the navigation
device securely on the carrier plate. To
and remove the navigation device, first take it
4
off from the carrier plate at the bottom.
.
6
on the top of the
7
. This unlocks the
6
is not present.
7
and fold down the navigation
6
Switching the Navigation device
on/off
2
With the button you can switch the
2
device off, on or to the sleep mode.