On The Windscreen; Adjusting The Unit Holder's Position; Attaching The Navigation Device; Removing The Navigation Device - Becker Active 43 Series Operating Instructions Manual

On the windscreen

The unit holder can be attached directly
to the windscreen using the suction mech-
anism.
> Press the carrier plate onto the four re-
taining lugs of the unit holder.
> Select a suitable spot to attach.
> Unscrew the fastening screws
a little.
5
> Press the base with its suction sur-
2
face against the windscreen. Turn
1
the unit holder such that the carrier
plate is positioned roughly in the de-
sired viewing direction.
> Press the lever down.
3
The holder has attached itself firmly to the
windscreen. It can now be adjusted with
precision. In order to remove it, operate
the lever again.
3

Adjusting the unit holder's position

> Loosen the fastening screws
until the carrier plate
without using excessive force.
> Move the carrier plate
quired position and hold it in this posi-
tion.
and
4
> Tighten the fastening screws
sufficiently so that the Navigation
5
device is held securely in place when the
vehicle is in motion.

Attaching the Navigation device

> Position the Navigation device, with
the attachment point on the bottom of
the housing, onto the carrier plate
> Without using excessive force, press the
Navigation device onto the carrier plate
. The Navigation device locks into
6
place.

Removing the Navigation device

Press the button
7
rier plate . This unlocks the Navigation
6
device which can be removed from the
carrier plate.
Switching the Navigation device
and
4 5

on/off

can be moved
6
Using the On/Off switch
to the re- switch the Navigation device on or off
6
completely.
Using the button
and Navigation device you can place the unit
4
in sleep mode or switch it on again from
sleep mode.
.
6
on the top of the car-
GENERAL OPERATION
you can
1
on the top of the
2
1
2
23
>>>
> D
> GB
> F
> I
> E
> PL
> CZ
> H
> RU