Adjusting The Unit Holder's Position; Attaching The Navigation Device; Removing The Navigation Device; Switching The Navigation - Becker GPS Navigator Operating Manual

>>> GENERAL OPERATION

Adjusting the unit holder's position

> Loosen the fastening screws
> D
until the carrier plate
5
> GB
moved without using excessive force.
> Move the carrier plate
> F
required position and hold it in this
> I
position.
> Tighten the fastening screws
> PL
sufficiently so that the Navigation
5
device is held securely in place when
the vehicle is in motion.

Attaching the Navigation device

> Position the Navigation device with the
attachment point on the bottom of the
housing, onto the carrier plate
> Without using excessive force, press
the Navigation device onto the carrier
plate . The Navigation device locks
6
into place.

Removing the Navigation device

Press the button
carrier plate
Navigation device which can be removed
from the carrier plate.
24
Switching the Navigation device
and
4
on/off
can be
6
Using the On/Off switch
to the switch the Navigation device on or off
6
completely.
Using the button
and Navigation device you can place the unit
4
in sleep mode or switch it on again from
sleep mode.
.
6
on the top of the
7
. This unlocks the
6

Switching on

> Set the On/Off switch on the
> Press the button on the top of the
you can
1
The
on the top of the manufacturer's logo appears on the
2
touchscreen.
1
When the Navigation device is started for
the first time, the language selection is
2
displayed automatically.
Using the
wheel, it is possible to scroll through the
list in the direction of the relevant arrow.
undersideof the unit to I.
Navigation device.
unit is switched
buttons or the scroll
on. The