Adjusting The Unit Bracket; Vertical Movements; Horizontal Movements; Adding The Traffic Assist Highspeed Ii - Becker Highspeed II Operating Instructions Manual

Adjusting the unit bracket

The support plate (7) can be swung
in two directions (horizontally and verti-
cally). It can thereby be set at virtually
every angle of vision to the driver.
Note:
Do not swing the support plate in both
directions at the same time! Before mo-
ving, always take the Traffic Assist
Highspeed II off the unit bracket.

Vertical movements

! Loosen the fastening screws (2) on
both sides far enough to be able to swi-
vel the carrier plate (7) downwards
from above without exerting excessi-
ve force.
Use one hand to hold the foot (5) and
!
swing the support plate (7) up to the
centre or down into the position you
want.
Tighten the fastening screws (2) suffi-
!
ciently so that the Traffic Assist High-
speed II is held securely in place when
the vehicle is in motion.

Horizontal movements

Loosen the locking screw (1) until the
!
support plate (7) can be swung from
left to right without too much effort.
Use one hand to hold the foot (5)
!
and swing the support plate (7) to the
left, to the centre or to the right into the
position you want.
! Retighten the locking screw (1) again
so that the Traffic Assist Highspeed II
is secure for travel.
General operations
Adding the Traffic Assist High-
speed II
The unit holder (6) is equipped with four
guides, the carrier plate (7) has corres-
ponding retaining lugs.
Position the unit holder with the gui-
!
des onto the carrier plate retaining
lugs.
Slide the unit holder downwards to the
!
stop.
The Traffic Assist Highspeed II has re-
ceptacles for the unit holder on the top
and bottom of the housing.
! Insert the Traffic Assist Highspeed II
into the unit holder with the receptac-
les on the bottom of the housing.
! Press the Traffic Assist Highspeed II
into the unit holder without employing
excessive force until the clip (8) enga-
ges in the receptacle.
Note:
To remove the Traffic Assist High-
speed II, press the clip (8) on the unit
holder with one finger and remove the
unit from the unit holder using your free
hand.
24