Barco Dpms Screen Saver Installation - Barco CORONIS 1MP System Manual

Wizard, click "Cancel". The wizard will ask you to confirm that you
want to cancel the DPMS installation, click "Yes" and then click
"Finish". The BARCO DPMS InstallShield Wizard will exit and
return to the BarcoMed Product Install Wizard Welcome Screen,
the wizard will automatically launch the CORONIS Rotation Service
Install Wizard, click "Cancel". The wizard will ask you to confirm
that you want to exit the CORONIS Rotation Service setup, click
"Exit Setup". The wizard will exit and return you to the BarcoMed
Product Installation Wizard. Then click "Back" and try reinstalling
the drivers following the steps above or using the steps outlined in
"Reinstalling or Updating your BarcoMed Drivers" section found
later in this chapter.
After returning to the BarcoMed Product Install Wizard Welcome
Screen, the wizard will clear the checkbox next to the BarcoMed Driver
and automatically launch the BARCO DPMS InstallShied Wizard.

BARCO DPMS Screen Saver Installation

9. Click "Next" on the Welcome Screen of the BARCO DPMS
InstallShied Wizard to begin the installation. Click "Cancel" to
cancel the DPMS installation and return to the BarcoMed Product
Install Wizard (figure 15 on the next page).
System manual Coronis 1MP
BarcoMed software driver installation
Figure 14
66