Disabling Dualview Under Windows 2000 - Barco CORONIS 1MP System Manual

Disabling DualView under Windows 2000

DualView can be disabled on your BarcoMed Display Controller(s)
through the Monitor Configuration section of the BarcoMed Driver Tab
of the "Display Properties Control Panel". Disabling DualView on one
BarcoMed controller will affect all BarcoMed controllers installed in
your system. To disable DualView follow the steps listed below.
1) Open the "Display Properties Control Panel" by right clicking on the
desktop, then select "Properties".
2) Click on "Settings" tab. Double click on the rectangle that
represents the first display attached to the BarcoMed Display
Controller you are working with to bring up its property page. Click
on the "BarcoMed Driver" tab.
3. Select "Disable DualView" from the "Monitor Configuration" drop
down menu (see figure 58 below). Click "OK", twice. Note: If you
are using a 3
key once and then "Enter" to select the 2
automatically shutdown and restart.
Figure 58: BarcoMed Driver Tab – Disabling DualView
4. When your machine comes back up, you may need to re-set up
your CORONIS displays with the desired display settings.
System manual Coronis 1MP
rd
party VGA card you may need to press the "Tab"
BarcoMed software driver installation
nd "OK". Your system will
98