Hovering the cursor over a display icon will pop up a window with
information that identifies the display.
Properties
You may acess the Properties page of the currently selected display,
which is represented by the monitor icon above with the black frame
around it, by either clicking on the "Properites" button or double
clicking on the icon.
BarcoMFD library
This is the version of the barcomfd library currently used. This library
provides APIs for interacting with the displays.
Coronis Display Properties
You may acess the Properties page of the currently selected display,
which is represented by the monitor icon above with the black frame
around it, by either clicking on the "Properites" button or double
clicking on the icon. This screen (figure 98) shows properties of the
currently active display.
Name: Displays the model name of the display.
Serial Number: Displays the serial number of the display.
Backlight RunTime: This is time in hours that the back light has been
on.
Firmware Revisions: This is the runtime firmware that is loaded in the
display. This information may be helpful when there is a problem.
Internal Temperature: This is the temperature inside the display. It
starts out at about the ambient temperature when the display backlight
is first turned on, then rises slowly to a steady-state temperature as the
display warms up. Changes in light level due to temperature variations
are completely controlled by the I-Guard sensor on the front of the
display.
Current Luminance Value: This is the current luminance value of the
display. It may vary a bit from time to time, for the display continuously
calibrates itself to meet the target luminance value.
System manual Coronis 1MP
BarcoMed software driver installation
136