Software Installation; Installing The Barcomed 3Mp2Fh, 2Mp2Fh Or 1Mp2Fh Windows Nt 4.0 Software; Using The Barcomed Product Installation Wizard - Barco CORONIS 1MP System Manual

SOFTWARE INSTALLATION

Installing the BarcoMed 3MP2FH, 2MP2FH or
1MP2FH Windows NT 4.0 Software
SPECIAL NOTE: Prior to installing the BarcoMed drivers and related
software you MUST install the BarcoMed Display Controller(s),
connect the CORONIS display panel(s) to the card(s), and turn the
CORONIS display panel(s) on. Refer to the Hardware Installation
section of this manual for instructions on installing the BarcoMed
Display Controller(s) and connecting them to the CORONIS display
panel(s).
The following software installation instructions presume that Windows
NT is already installed on your system. If you need to install or reinstall
Windows NT on your system you must first remove the BarcoMed
Display Controller(s) and use a 3
during the Windows NT installation process.

Using the BarcoMed Product Installation Wizard

To install your BarcoMed 3MP2FH, 2MP2FH or 1MP2FH Windows
Display Controller Driver, BARCO DPMS Screen Saver and
CORONIS Rotation Service for the first time follow the steps below. If
you are reinstalling the drivers or installing a new driver release over
an existing driver release, skip step 1 below:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the Hardware Installation section of this manual for
more information.
2. Boot the machine, log in using an account with administrator
privileges and follow these steps.
3. Insert your BarcoMed Software CD into your computer's CD drive.
The "BarcoMed Software Product Installation Wizard" should start
automatically. If it doesn't start within 3 minutes, browse the
contents of your BarcoMed Software CD and double click on the
file, "Setup.exe" to start the wizard.
The BarcoMed Product Installation Wizard will start by inspecting
your system to make certain that all of the necessary Windows
components are up to date. If it determines that the Microsoft
Installer is current, the BarcoMed Product Installation Wizard will
start by displaying the screen shown in figure 6. If it determines
that the Microsoft Installer is either out of date or missing, it will
display the screen shown in figure 4. Click "OK" to continue, the
wizard will then install a newer version of the Microsoft Installer.
System manual Coronis 1MP
BarcoMed software driver installation
rd
party VGA card and VGA monitor
60