Installing The Barcomed 3Mp2Fh, 2Mp2Fh Or 1Mp2Fh Display Controller - Barco CORONIS 1MP System Manual

Installing the BarcoMed 3MP2FH, 2MP2FH or 1MP2FH Display
Controller
Install the 3MP2FH, 2MP2FH or 1MP2FH into your computer following
these steps:
1. Turn off the power to your computer and disconnect the power
cord.
2. Remove the chassis cover according to the manufacturer's
instructions. Be sure to observe safety warnings.
3. If you have decided to use the on-board VGA capabilities of the
3MP2FH, 2MP2FH or 1MP2FH (see Using the VGA capabilities of
the BarcoMed 3MP2FH, 2MP2FH or 1MP2FH), you must now
remove any VGA cards that are currently installed in the computer.
4. Install the 3MP2FH, 2MP2FH or 1MP2FH Display Controller into a
free PCI slot, either 32 bit or 64 bit (see figure 2, for examples of
slots). Be sure that the display controller is seated firmly in the slot.
5. Secure the card to the chassis with the PC's I/O panel mounting
screw, and replace the chassis cover.
6. Connect the primary display (left most display in a linear
configuration, top most in a vertical configuration) to the uppermost
connector on the 3MP2FH, 2MP2FH or 1MP2FH (the output
farthest from the motherboard – "VID 1" in figure 3) using the
provided DVI cable. For a dual-headed 3MP2FH, 2MP2FH or
System manual Coronis 1MP
Figure 2: PCI and RAID Controller Slots
Imaging board installation
19