Re-Enabling Dualview Under Windows 2000 - Barco CORONIS 1MP System Manual

Re-enabling DualView under Windows 2000

If you have disabled DualView using the method described on the
previous page and decide you want to re-enable it. Re-enabling
DualView on one BarcoMed controller will re-enable it on all the
BarcoMed controllers installed in your system. Following the steps
listed below.
1) Open the "Display Properties Control Panel" by right clicking on the
desktop, then select "Properties".
2) Click on "Settings" tab. Double click on the rectangle that
represents the displays attached to the BarcoMed Display
Controller you are working with to bring up its property page. Click
on the "BarcoMed Driver" tab.
3. Select "Enable DualView" from the "Monitor Configuration" drop
down menu (see figure 59 below). Click "OK", twice. Click "OK",
twice. Note: If you are using a 3
press the "Tab" key once and then "Enter" to select the 2
Your system will automatically shutdown and restart. Your system
will automatically shutdown and restart.
Figure 59: BarcoMed Driver Tab – Enabling DualView
4. When your machine comes back up, you may need to re-set up
your CORONIS displays with the desired display settings.
System manual Coronis 1MP
BarcoMed software driver installation
rd
party VGA card you may need to
nd "OK".
99