Installing The Barcomed 3Mp2Fh, 2Mp2Fh Or 1Mp2Fh Windows Xp Software; Using The Barcomed Product Installation Wizard - Barco CORONIS 1MP System Manual

Installing the BarcoMed 3MP2FH, 2MP2FH or
1MP2FH Windows XP Software
SPECIAL NOTE: Prior to installing the BarcoMed drivers you MUST
install the BarcoMed Display Controller(s), connect the CORONIS
display panel(s) to the card(s), and turn the CORONIS display panel(s)
on. Refer to the Hardware Installation section of this manual for
instructions on installing the BarcoMed Imaging Board(s) and
connecting them to the CORONIS display panel(s).
The following software installation instructions presume that Windows
XP is already installed on your system. If you need to install or reinstall
Windows XP on your system you must first remove the BarcoMed
Display Controller(s) and use a 3
during the Windows XP installation process.

Using the BarcoMed Product Installation Wizard

To install your BarcoMed 3MP2FH. 2MP2FH or 1MP2FH Windows
Display Controller Driver, BARCO DPMS Screen Saver and
CORONIS Rotation Service for the first time follow the steps below. If
you are reinstalling the drivers or installing a new driver release over
an existing driver release skip to the step 7 on the next page:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the hardware installation guide that came with your
BarcoMed Display Controller(s) for more information.
2. Boot the machine and log in using an account with administrative
privileges.
3. Windows XP will do a thorough inspection of your system and will
announce that it has found new hardware. Please be patient as
this may take up to 5 minutes.
4. Close any informational balloons that Windows XP may open in the
lower right hand corner of the monitor.
5. Windows XP will automatically launch the "Found New Hardware
Wizard" (figure 60 on the next page). Click "Cancel" to exit the
Wizard.
System manual Coronis 1MP
BarcoMed software driver installation
rd party VGA card and VGA monitor
100