Troubleshooting - Barco CORONIS 1MP System Manual

TROUBLESHOOTING

Windows does not show the desired display
settings
Should you have problems selecting display settings for portrait
oriented displays in the Windows Display Properties control panel,
disable the option Hide modes that this monitor cannot display in
the control panel (see below).
Information:
The display contains a special memory chip that contains information
about the display's scanning capabilities. When Windows starts up, it
reads the contents from this memory and presents a number of display
settings in the Display Properties control panel, based on this informa-
tion.
The memory of this display contains the information the display can
Hide modes that this monitor cannot display in the control panel is
enabled.
Pixel Faults
Permanently dark or bright pixels can happen to TFT displays. 10 or
less permanently dead pixels do not make out a good case for ex-
changing the unit.
Please contact our Customer Service Department if the number of
pixel faults exceeds the above-mentioned figure.
System manual Coronis 1MP
handle scanning systems up to 120 Hz. That is why
Windows will propose a display setting with a high
refresh rate. However, it is best to select a refresh
rate of 60 Hz.
The information that the display can be used in
portrait mode, is also stored in the display memory.
However, Windows does not recognize this and
presents only default landscape modes if the option
Display installation
52