Routine Maintenance; Optional Accessories - Axminster WS1000TA User Manual

Fig 76
Co-Matic AF32 Junior Power Feed in operation
DISCONNECT THE MACHINE FROM THE MAINS SUPPLY!
Spindle Moulder
• Keep the cutter block clean and free from dust build up.
• Check the cutter block regularly for chipped blades and damage to block i.e cracks in the cutter block.
• When changing the cutter block, remove the cutter block and place safely away, clean the spindle by spraying a
light coating of oil over the shaft and install a new cutter block.
•Opening the access door for the spindle moulder, check the belt tension. If the belt is loose, using the 10mm
allen key lossen the motor caphead bolt and push/pull until the belt is under tension again, tighten the motor
bolt to keep the tension.
• If the "Spindle Moulder" is not going to be used for a period of time spray, a light coat of oil over the table
service and blades, this will help prevent rust and place a dust sheet over the spindle moulder.
Major Service
After several months of constant use the condition of the chains, sprockets and tension of the drive belts and the
treaded drive shafts of the rise and fall tilt mechanisms will need to be checked, that will require a service
engineer to see over the job. If you find that the machine is not performing as it should please contact "Axminster
Tool Centre" by phone on 0800 371822.

Optional Accessories

Co-Matic AF32 Junior Power Feed

Routine Maintenance

Fig 77
29