Optional Accessories - Axminster WS1000TA User Manual

Optional Accessories

The spindle moulder can be fitted with the following
optional accessories:
• Sliding Table Extension Order No: 950505
See fig 74)
This accessory is a support table complete with a
telescopic support arm. It clamps to the sliding table to
provide extra support when machining panels or the
ends of long boards. Supplied with a long fence arm
and length stop. The telescopic arm requires mounting
to the machines chassis using the mounting hole
provided. Some care should be taken when mounting
the arm to ensure that the table stays level throughout
its travel.
• Tenon Plate Order No: 950506 (See fig 75)
This accessory is a simple alloy plate that lifts the work
piece above the table. This means that you can
machine the top and bottom surface of the work, such
as when creating a tenon. It can be mounted next to
the mitre fence and clamp so as to make the
machining of end grain material as safe as possible.
•Co-Matic AF32 Junior Power Feed
Order No: 340195 (See figs 76 & 77)
Fig 74
Sliding Table Extension Assembly
28
A medium weight power feed unit with three white
rubber rollers, all spring-loaded to provide a constant
feed rate on either a planer, saw bench or spindle
moulder. There is a choice of four feed speeds, easily
selectable by removing the side plate and
re-positioning the drive gears. The horizontal and
vertical position of the drive head can be precisely
adjusted with the aid of the two adjusting screws and
then securely locked in place with the two handles.
An additional feature is the ability to rotate the head
through 90° so that pressure can be applied to the
work in either the vertical or horizontal planes. The unit
is secured to the table of the machine, either by bolting
through or by screwing into holes tapped into the cast
iron bed. If drilling the holes into the table of your
machine is too disheartening then the purchase of the
universal quick fix support plate (800430) is an
excellent solution.
The plate bolts onto the corner of a table and is
clamped in place with the bolts provided. The top of
the plate is drilled and tapped to accept all of the
power feed units we offer, allowing the unit to be
bolted on to whichever machine it is required on.
Fig 75
Tenon Plate