Setting Up The Machine - Axminster WS1000TA User Manual

Setting Up the Machine

Setting the fence
The fence is a two piece adjusting system. Each fence is independently adjustable to compensate for different
cutting thicknesses.
Make sure the fence is square to the work surface, place a 90˚ square up against the fence and check it is
perpendicular to the work surface. If it is not, turn the fence adjusting knob (a) until it is correct (See figs 55
and 56).
Place a straight edge up-against the fence, loosen the fence advancing clamping knobs & turn the fence
advancing knobs (b) until both fences are aligned (See figs 57 & 58).
Fig 55
Fig 57
Adjust the advancing knobs (b) until both
fences are aligned
Adjust the position of the fence assembly to give both the required cutter protrusion and adequate clearance
between the cutter and the fence. Close up the aluminum fences to give approximately 5mm clearance around
the cutter (see fig 59).
The fence is used to guide small workpieces through the cutter without them being trapped between the fence
and the cutter. The dust extraction hose is connected to the aperture at the rear of the fence casting.
Before starting work, carefully check that the cutter can rotate freely without fouling the inside of the guard and
that the guard is clamped firmly in place.
22
Place a 90˚square up against the fence and check it is perpendicular
A
B
Place a straight edge up-against the fences
and check they are aligned
Fig 56
Fig 58