Fig 59 - Axminster WS1000TA User Manual

Adjusting the feeder roller & ant-kickback assembly
Loosen the feeder roller clamping knobs (a and b) & move the feeder roller to the centre of the workpiece,
tighten the clamping knobs. Undo the anti-kickback clamping knobs (c and d) and move the assembly near the
workpiece, tighten the clamping knob (c), raise the assembly so the steel plate is about 5-10mm above the work
table (See figs 60 & 61).
Fig 60
c
d
Leveling the sliding table
Place a level between the sliding table & work table & check that both tables are level. If not loosen the three nuts
(e) beneath the sliding table and adjust the two coach bolts (f ), until the bubble on the level is between the two
markers (g), tighten the three nuts (e) (See figs 62 & 63).
Fig 62

Fig 59

5mm
A
b
G
Setting up the Machine
5-10mm
Fig 61
F
Fig 63
E
23