Axminster WS1000TA User Manual page 16

Assembly
Step 5
Mi tre Fence Work Clamp Assembly
Locate the pre-drilled metal plate (F3) & slot it into the machined 'T' slot in the sliding table (See figs 35-36).
Lower the mitre fence casting (F1) on top of the metal plate (F3), line up the machined slot & pre-drilled hole in
the mitre fence casting with the holes in the metal plate, see fig 37, locate the M10 clamping knob (F4) with
washer & screw it through the hole in the casting into the metal plate (F3) (See fig 38). Locate the lift and shift
handle (F5) and screw it through the machined slot into the remaining pre-drilled hole and lightly tighten (See
fig 39). Lastly locate the work clamp (F2) and slide it onto the steel rod, clamp in place by tightening the clamping
knob (See fig 40). (DO NOT OVERTIGHTEN)
Fig 35
Fig 37
Fig 39
16
'T' Slot
F1
F5
F4
F2
Fig 36
F3
Fig 38
Fig 40